Table of Contents
Advertisement
2.2 Interval Photo
In the interval photo mode, the camera will take a single photo at a set time
interval until stopped.
To enter Interval Photo mode, power the camera on and press the MODE
button to access the mode selection screen and use the UP or DOWN
buttons to select Interval and press the OK button to enter that mode.
1. Line up your shot by looking at the LCD screen to see what is in the shot.
2. Hold the camera steady and press the SHUTTER button to capture a
photo and start the countdown.
3. At the end of each countdown, a new photo will be captured, each
captured photo will be saved as an individual file.
4. To end the interval photo, press the SHUTTER button.
5. The number of photos that can be captured at a particular resolution will
be displayed at the top of the screen.
6. The number of pictures remaining will be 0 if there is no memory card
be shown on the screen when the memory card is full.
7. The number of remaining photos is determined by the selected photo
resolution. The higher the photo resolution, the lower the number of
photos you are able to be save to the memory card. Before capturing any
photos, you can select a preferred photo resolution.
The front LCD screen can be used to take selfies. Simply press the SWITCH
SCREEN button and the front LCD screen will turn on. Then use the camera
as normal. Press the SWITCH SCREEN button to turn the rear LCD screen
back on.
Note: Only one LCD screen is active at a time, when one of the screens is off,
this is not a malfunction.
2.2.1 Photo Size
This function sets the photo resolution. The higher the resolution, the greater
the photo quality and the larger the file size of the photo.
1. In Interval Photo Mode press the MENU button.
20
Advertisement
Table of Contents
