Arms & Restraints - rav KPH-40ECGA Installation Manual

20. Arms & Restraints: Before installing arms,
raise carriages to a convenient height. Grease swivel
arm pins and holes with Lithium grease. Slide arm
into yoke, Fig. 25a. Install 1-3/4" diameter arm pin(s)
and arm stop, Fig. 25a.
Install Spring Pin to secure arm pin in place, Fig. 25a.
Note: Arm stop will be required on the drive
in side of the power unit side. Install at
same time as arm pin, Fig. 25b. Notice the
orientation of arm stop in Fig. 25c.
After installing arms and pins, install arm Restraint
Gears as follows: Install Restraint Gear onto arm
clevis, as shown, Fig. 26a. Ensure side of gear
marked TOP is facing upward, Fig. 26a.
CAUTION
46
Note: Location and
Orientation of Arm Stop
Fig. 25a
NOTE: Once arm is installed in yoke, pull up actuator
pin and swing arm fully around, being sure that the
Restraint Gear and Gear Block always stay aligned.
If they do not stay aligned, remove restraint gear and
install in the opposite position.
Installation
Pinch Point
Keep Hands
Above Groove
0496-M005-0
Fig. 25c
TOP will be marked on
top side of restraint gear
Fig. 25b
Arm stop
NOTE beveled
gear orientation
Fig. 26a