Column Extensions; Reinforcement Bar; Latch Cable Guides; Lift Setting - rav KPH-40ECGA Installation Manual

5. Column Extensions: Install the column
extensions using (2) 1/2"-13NC x 1 1/4"
Carriage HHCS and Nylon Locknuts, Fig. 5.
Fig. 4
Fig. 5
1/2"-13NC x 1-1/4" HHCS &
1/2" Flat Washer
6. Reinforcement Bar: Install the reinforcement
bar to the column and column extension using
(2) 1/2"-13NC x 1-1/4" HHCS, (4) 1/2" Flat
Washer, and (2) 1/2"-13NC Nylon Locknut
Fig. 6.
Fig. 5
Fig. 6
1/2"-13NC x 1-1/4" HHCS
& 1/2" Flat Washer
1/2"-13NC Nylon Locknut
& 1/2" Flat Washer
1/2"-13NC Nylon Locknut
& 1/2" Flat Washer
0496-M005-0
7. Latch Cable Guides: Install the latch cable
conduit guide brackets to column extensions with
(1) 1/4"- 20NC x 1" HHCS and 1/4"-20NC Flanged
Locknuts, HHCS should go through hole nearest
the edge as shown, Fig. 7.
8. Lift Setting: Position columns in bay using
dimensions shown in Fig. 1a & Fig. 1b. Place
column with power unit mounting bracket on
vehicle passenger side of lift. Both column base
plate backs must be square on center line of lift.
Notches are cut into each base plate to indicate
center line of lift. Use appropriate equipment to
raise carriage to first latch position. Be sure locking
latch is securely engaged.
Fig. 7 Fig. 6
9. Cylinder Fitting: Push the carriage to first
lock and then install the Fittin to the cylinder
through the small opening on the bot- tom of
the column. Fig 8.
CAUTION:
Overtightening will damage fitting
resulting in fluid leakage.
Fig. 8
Fig. 7
Fitting
Hose
33