Operating Instructions - rav KPH-40ECGA Operation And Maintenance Manual

Two post lift

Hide thumbs Also See for KPH-40ECGA:

Installation manual (122 pages)

Table of Contents

Available languages

WARNING: To avoid personal injury and/or property damage, permit only trained personnel to

operate lift. After reviewing these instructions, get familiar with lift controls by running the lift

through a few cycles before loading vehicle on lift.

IMPORTANT: Always lift the vehicle using all four adapters. NEVER raise just one end, one corner,

or one side of vehicle.

Before Loading: Lift must be fully lowered and

service bay clear of all personnel before the

vehicle is brought on lift. Swing arms out to full

drive-thru position.

Spot vehicle over lift. Make sure you are using

the correct adapter, Fig. 1.

Loading: Swing arms under vehicle and

position adapters at vehicle manufacturer's

recommended lift points, Fig. 2.

Use intermediate, high step, or optional

adapters for under body clearance when

required.

Note: Allow (2) seconds between motor starts.

Failure to comply may cause motor burnout.

DO NOT rest adapter against edge of arm.

To Raise Lift:

A.For all lifts. Push Raise switch on power unit,

Fig. 3.

B. Stop before making contact with vehicle. Check

arm restraint pins for engagement. If required,

slightly move arm to allow restraint gear and

pawl to mesh. DO NOT hammer pin down as

this will damage the restraint gear teeth.

C. Raise vehicle until tires clear the floor.

D. Stop and check adapters for secure contact

at vehicle manufacturer's recommended lift

points.

E. Continue to raise to desired height only if

vehicle is secure on lift.

F. Do Not go under vehicle if all four adapters are

not in secure contact at vehicle manufacturer's

recommended lift points.

G. Repeat complete spotting, loading and raising

procedures if required.

H. Lower lift onto locking latches.