C-Fly FAITH 2 User Manual page 15

Hide thumbs

Table Of Contents

Table of Contents

190,, 111,.111, ..

49====

SEIM

MEM

Trp

Tap the " " button in the upper right

corner of the APP

1=1

Enter the "General Settings" menu

Calibration Interface 2

Vertical Calibration / Horizontal Calibration

24 I

Flight

Compass Calibration via APP

(1)Enter calibration mode:

After the dronet is connected to the APP, tap the "..." button in the upper right corner of the APP control

interface to enter the "General Settings" menu,Then tap the "Calibration" button.

When the APP pops up a prompt, check the current environment and keep away from metal objects as

prompted. Then tap the "Calibration" button

In this case, when the status indicator on the rear arm of the drone flashes blue and red alternately, the

compass calibration mode starts.

(2)Compass Calibration

• When the APP prompts to rotate the drone horizontally, place the drone horizontally in the

hand, then turn the drone horizontally until the status indicator on the rear arm of the drone changes to an

alternatively flashing red and green light, which means that the horizontal calibration is successful

• Vertical Calibration:when the APP prompts to place the drone's head to be up and rotates, place the

drone in the hand and ensure that the drone body is perpendicular to the ground; then rotates the drone

horizontally. When the status indicator on the rear arm of the drone turns green (solid or flashing), the

compass is successfully calibrated,At this time, the APP will prompt "Calibration Successful", then tap

"Finish" to end the calibration process,lf the status indicator turns to solid red light for about 6 seconds,

the compass calibration fails. Please go to another location and recalibrate.

Note

• After changing the flight site, make sure to calibrate the compass before the first flight.

• If the aircraft indicator flashes blue and green alternately during flight, which means that the compass is

abnormal and need to calibrate.

• Stay away from the environment with magnetic interference when calibrating, otherwise the calibration

may fail.

• Do not calibrate in areas with strong magnetic fields, such as magnetic mines, parking lots, and building

areas with underground reinforcement.

• Do not calibrate with carrying ferromagnetic materials such as keys, mobile phones, etc.

• Do not calibrate when large pieces of metal are nearby.

Basic Flight Operation Steps

•

(1) Place the drone in a wide open area that its front is user's front.

(2) Turn on the drone and remote controller.

(3) Connect the remote controller with the drone and then proceed drone self-diagnostic tests.

(4) Connect the APP with mobile device and enter into the FPV interface.

(5) Unlock the drone after the a pp indicate: ready go.

(6) Pull up the throttle stick then the drone takes off, and control the drone flight by left/right stick.

(7) F Pull down the throttle stick to land the drone.

(8) Pull down the throttle stick to the bottom position and keep for 3 seconds to lock the drone.

(9) Pull out the battery from the drone and then turn off the remote controller

Video Suggestion and Tips :

(1) Make sure components of the drone are normal before flight.

(2) Choose sunny, windy weather for recording.

(3) Perform test flights to establish flight routes and to preview scenes.

(4) Push the control stick gently to keep the drone movement smooth and stable.

(5) Choose appropriate gimbal shooting angle.

(6) Try to record the videos under Positioning Mode.