Mount And Tighten Screws - KTM 250 EXC TPI EU 2018 Setup Instructions

2 SETUP
4
Info
An assistant prevents the motorcycle from falling
over.
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you
have finished.
–
Remove and unpack the separate enclosure and attach-
ments. Check that the scope of supply is complete using
the enclosed packing list.
–
Have a lift stand available.
Lift stand (78129955100)
–
Remove the two cable ties on the triple clamp.
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle and attachments for transport damage.
–
Install the shock absorber. (
402051-01
(All EXC models)
–
Position the turn signal indicator lamp
bination instrument bracket.
H02474-10
(All EXC models)
–
Position the connector retainer and combination instru-
ment on the upper triple clamp.
–

Mount and tighten screws

Guideline
Remaining screws,
chassis
H02537-10
(250 XC‑W TPI US)
–
Position the combination instrument on the upper
triple clamp.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
H02538-10
p. 24)
1 in the com-
2
.
M6 10 Nm
(7.4 lbf ft)
2
with the collar bushings.
M6 10 Nm
(7.4 lbf ft)