Hard Drive - HP 200 G1 ST Maintenance And Service Manual

Hard drive

Description
1 TB, 7200 rpm, hard drive
500 GB, 7200 rpm hard drive
The hard drive must be connected to the dark blue primary SATA connector on the system board labeled
SATA0.
NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
CAUTION: To prevent loss of work and damage to the computer or drive:
If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and
unplug the power cord. Do not remove a drive while the computer is on or in standby mode.
Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid
touching the connector. For more information about preventing electrostatic damage, refer to
discharge information on page
Handle a drive carefully; do not drop it.
Do not use excessive force when inserting a drive.
Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as
monitors or speakers.
If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the
package "Fragile: Handle With Care."
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power cable and data cable from the back of the hard drive.
6.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 26).
15).
Electrostatic
14).
Hard drive 27