Failure Display And Inspection - Candy CI3640 ELITE Instruction Manual

Pans do not
become hot and
appears in the
display.
The induction hob
or a cooking zone
has turned itself
off
unexpectedly, a
tone sounds and
an error code is
displayed
(typically
alternating with
one or two digits
in the cooking
timer display).

Failure Display and Inspection

If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem Possible causes
F0/F1/F2 Fan failure
F3-F8 Temperature sensor failure
F9-FE
Temperature sensor of the IGBT
failure.
E1/E2 Abnormal supply voltage
E3/E4 Abnormal temperature
E5/E6 Bad induction hob heat
radiation
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and
damages to the induction hob.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot detect
the pan because it is too small for
the cooking zone or not properly
centred on it.
Technical fault.
Use cookware suitable for
induction cooking. See section
„Choosing the right cookware‟.
Centre the pan and make sure that
its base matches the size of the
cooking zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
What to do
Please contact the supplier
Please contact the supplier.
Please contact the supplier.
Please inspect whether
power
supply is normal.
Power on after the power
supply is normal.
Please inspect the pot.
Please restart after the
induction hob cools down.
EN-24