Checking The Rubber Buffer And Pivot Points Of The Shock Absorber (Sx-E 3); Removing The Seat - KTM SX-E 3 2024 Owner's Manual

13 SERVICE WORK ON THE CHASSIS
13.20
13.21
58
M02022-11
Checking the rubber buffer and pivot points of the shock absorber (SX‑E 3)
M02071-10

Removing the seat

H00066-10
(SX‑E 5)
–
Push splash protector
–
Mount the shock absorber with screw
Guideline
If necessary, observe the installation position noted dur-
ing removal.
Screw, top M10x42
shock absorber
–
Lift the link fork, mount screw
Guideline
Screw, bottom M10x52
shock absorber
–
4
Attach brake line
Finishing work
–
Remove the motorcycle from the lift stand. (
Condition
The shock absorber is removed.
–
1
Check rubber buffer and pivot points
absorber for damage and wear.
» If there is damage or wear:
–
Change shock absorber.
–
1
Open quick release and raise the rear of the seat.
–
Pull back the seat and remove it.
1
to the side.
2
.
45 Nm (33.2 lbf ft)
Loctite
3
and tighten it.
45 Nm (33.2 lbf ft)
Loctite
to the holder.
p. 46)
2
of the shock
® 243™
® 243™