Table of Contents
Advertisement
3.7
Parameter Changes – "Ok" key
Whenever setting values are being modified the »Ok« key is used to make the device accept
the new value. But note that for modifying one value, the »Ok« key must be pressed twice:
Operational
When pressing »Ok« for the first time, the new value is stored temporarily. Only after it has
been pressed for a second time, the new value gets active.
EDR-3000
Meas
Operational
Ack/Rst
Info
Device Planning
Operational
Info
Ack/Rst
Device Planning
50P[2].Mode
-
ℹ General Operation Mode
Ack/Rst
Info
Operational
Enter Password
Supervisor-Lv3
* * * *
1
2
Ack/Rst
Info
E-Series Family Quick Start Guide
Menu
Ok
CTRL
Ok
CTRL
1.
2.
Ok
CTRL
3
4
Ok
CTRL
For example, let us assume we want to modify
the value of »50P[2] . Mode«.
This setting can be found in the Device
Planning menu branch, and its purpose is
to activate (or deactivate) the protection
function »50P[2]« (i. e. the 2
Overcurrent protection).
Enter the Device Planning menu branch.
Then press the "▼" (Down) Softkey repeatedly,
until the required setting can be seen in the
display.
Remark: Directly above the Softkey
assignments, there is a line starting with "ℹ".
It shows a description of the currently selected
parameter.
Then press the "Key" Softkey to enter the Edit
Mode for this particular setting.
You are asked for the password. Settings in
the Device Planning menu branch require the
Supervisor access level.
Type in the digits for the password using the
Softkeys "1" ... "4", then press the »Ok« key.
www.eaton.com
3 Quick Start – Operation via Panel
3.7 Parameter Changes – "Ok" key
nd
stage of the
39
Advertisement
Table of Contents
