Table of Contents
Advertisement
5.6
Obstruct error
Table 14 - Obstruct error
Possible cause
Head/stylus configuration
obstructed
Probe extension
combination too long
Internal head fault
5.7
Overload error
The OVERLOAD ERROR and STOP LEDs are lit on the controller. The head has been
overloaded while locked.
Table 15 - Overload error
Possible cause
Head lock up holding force
exceeded during CMM
acceleration
Collision with work piece or
CMM
Checks/remedies
Check head for damage.
Remove obstruction and repeat head move.
Use shorter/lighter styli combination.
Contact your Renishaw representative, CMM
manufacturer or distributor.
Checks/remedies
Reduce mass of probe combination.
Reduce acceleration.
Check head for damage.
Remove obstruction and repeat move.
Troubleshooting
41
Advertisement
Table of Contents
