Error Messages And Alarms - Renishaw TRS1 Programming Manual

8

Error messages and alarms

Error messages and alarms
When an error state is detected, an error message is displayed on the screen of the
controller. Error messages, their meaning, and typical actions needed to clear them are
described below.
Message
Meaning
Action
Message
Meaning
Action
Message
Meaning
Action
BROKEN TOOL
The tool is out of tolerance.
Replace the defective tool and establish the correct tool offset value.
NO H OFFSET ACTIVE
There is no active tool offset.
Correct the part program and run the program again.
FORMAT ERROR
A macro input is either missing or the value entered is incorrect.
Correct the macro input line then run again.
Publication No. H-2000-6403