Table of Contents
Advertisement
SECTION 4 Installation and component assembly (continued)
• Evaporator LEFT-RIGHT level.
a. Using a level, adjust the left and right legs of the front section of the evaporator to bring it perfectly level.
b. Repeat step (a) for the rear section of the evaporator.
• Evaporator FRONT-REAR level.
NOTE: The part of the evaporator that lies between the two side legs is called a SECTION. See Illustration 1 above.
a. From the front of the left side, adjust the first section so that it is level.
b. In the same way, extend the levelling of all sections backwards from leg to leg.
c. Check if the rear section is still on the left-right level.
• If not, adjust the rear leg on the opposite side to bring this section back to level.
d. Repeat steps (a) (b) and (c) for the right side of the evaporator.
• Check all LEFT-RIGHT and FRONT-REAR levels and adjust as necessary until the evaporator is perfectly level.
You may need to repeat this step a few times.
Place the pans in the evaporator.
• Fill the pans with water to check if the evaporator is still level.
• Your evaporator is considered level if it meets the following tolerance:
- measure the height from the water surface to the rim in each corner of the pan,
- the difference between the highest and lowest height must be less than 1/8 in. (4 mm),
- otherwise, the previous levelling steps must be repeated.
4.2 MASONRY AND INSULATION
The masonry and insulation work has already been done at the plant on your FUSION X
4.3 INSTALLING THE CHIMNEY AND THE STEAM VENTS
4.3.1
LWS listed chimney
See the user manual for the listed chimney. Copies of the manual are located with your evaporator's documents
and in the rain cap box.
4.3.2
Single wall chimney (non-listed)
See Appendix A for single wall chimney installation.
4.3.3
Steam vents
See Appendix B for steam vent installation.
Lapierre Equipment |
FUSION X
2
EVAPORATOR
| USER MANUAL | Version 01 - September 2022
14
2
evaporator.
Advertisement
Table of Contents
