Table of Contents
Advertisement
SECTION 4 INSTALLATION AND COMPONENT ASSEMBLY
To reduce the risk of fire, electric shock or injury, it is important to follow these instructions when installing your
equipment.
• The installation of the power supply must be done by a properly qualified contractor. The work must be
carried out in accordance with the local regulations in effect.
• If you have to work in existing walls and ceilings, be careful not to damage electrical conduits or other utilities
that may be present.
Your FUSION X
STABLE SURFACE. If it tips or tilts, it may cause severe injury or burns to the operator and others
in the vicinity of the equipment. Its weight and the heat of its contents present a real danger.
4.1
LEVELLING THE EVAPORATOR
On receipt, the evaporator will have been placed at its exact location in its space. This location must comply
with the conditions set out in Section 3.1.1: Determining the location of the evaporator, in terms of mode of
operation, required clearances and positions of the chimney and vents in the ceiling and/or roof.
IMPORTANT | It is very important that the evaporator is level and perfectly horizontal for proper operation.
Levelling can be done with the pans in place or with the evaporator combustion chamber alone.
The evaporator is equipped with height-adjustable legs to allow levelling of the equipment. Below you will find
the steps to follow.
ILLUSTRATION 1 | Levelling the FUSION X
VUE DE FACE
FRONT VIEW
NIVEAU GAUCHE-DROIT
LEFT-RIGHT LEVEL
The part of the evaporator that lies between two side legs is called a SECTION.
Lapierre Equipment |
2
evaporator must be SAFELY INSTALLED ON A HORIZONTAL AND PERFECTLY
2
evaporator
NIVEAU AVANT-ARRIÈRE
FRONT-REAR LEVEL
FUSION X
2
EVAPORATOR
VUE DE CÔTÉ
SIDE VIEW
| USER MANUAL | Version 01 - September 2022
13
SECTION
Advertisement
Table of Contents
