Advertisement
12. Repeat steps to affix the other end of the cable to the buckle on the
same side horizontal stabilizer. Finally, cut off any excess cable. Then
proceed to do the same on the other side.
(Note: Do not over tighten the cable because it can cause the horizontal
stabilizer to not be level and affect flight characteristics.)
13. Pass the remaining two cables through the sleeve, make a loop, and
then thread them back into the sleeves while leaving a cable loop with
a diameter of about 3mm. Then clamp the sleeve with pliers. Next,
remove the second tail wheel screw. Align the cable loop holes of the
two cables with the tail wheel screw hole, and then reinsert the screw
back into the fuselage. Finally, fix the other end of the cable to the
pull buckle on the same side horizontal stabilizer from previous steps.
Be sure to cut off the excess cable.
Advertisement
