Maintenance - Husqvarna T 4000 Petrol Operator's Manual

Hide thumbs Also See for T 4000 Petrol:
Table of Contents

Advertisement

Available languages

Available languages

2. Push the green button (A) on the power switch to
start the dust extractor.
3. Let the dust extractor operate for some minutes until
it is warm.
To stop the dust extractor
1. Push the red button (B) on the power switch to stop
the dust extractor.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
WARNING:
safety chapter before you do maintenance
on the product.
Note:
Refer to the full generator operator's manual
for generator maintenance information that is not found
here.
Operation
Clean the generator.
2065 - 001 - 12.06.2023
A
B
A
B

Maintenance

Read and understand the
Read and understand the
Before
Each 20 h
each
Daily
or monthly
use
X
To stop the generator
1. Stop the dust extractor.
WARNING:
generator if the dust extractor is on.
2. Let the generator operate without a load for 30
seconds.
3. Set the power switch to the OFF position "0".
4. Close the fuel valve.
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
* Clean at a more regular interval if the product is used
in conditions with much dust.
** Maintenance must be done by an approved servicing
dealer.
Each 50 h
When
Each
or 3
suction
300 h
months
is low
Do not stop the
I
O
Each
Each
2000 h
Each 2
1000 h or
or 12
years
6 months
months
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

967 97 33-01

Table of Contents