Maintenance - Husqvarna DC 6000 Operator's Manual

Introduction
WARNING:
equipment, refer to
equipment on page 80 , during service. Dust
can be exposed during maintenance and
service.
WARNING:
machines occur during trouble shooting,
service and maintenance as staff have to
locate themselves within the risk area of the
machine. Prevent accidents by being alert
and by planning and preparing the work.
WARNING:
switched off during operations described in
this chapter unless otherwise stated.

Maintenance

Look for signs of wear, damage or
loose connections of the power cord.
Replace the power cord if it is nec-
essary.
Clean the surface of the product.
Do a check of the filter and filter
housing. Clean the filter and filter
housing if it is necessary. Refer to
To clean the filter on page 89 .
Do a check of the dust hose and the
connections.
Do a check of the cyclone and the
container.
Do a check of the rubber below the
cyclone.
Do a check of the metal mesh in the
cyclone container.
Clean the air compressor filter. Re-
place the air compressor filter if it is
clogged.
Clean the filter for the compressed
To clean the fil-
air dryer. Refer to
ter for the compressed air dryer on
page 87 .
Wash the filters with a soft water jet.
1883 - 001 - 01.06.2022
Maintenance
Use personal safety
Personal protective
Most accidents involving
The motor should be
Daily
X
X
X
X
WARNING:
components should only be performed by a
licensed electrician.
Maintenance schedule DC 6000
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
CAUTION:
or sharp objects when you clean the filters.
Weekly Monthly
X
X
X
X
X
All checks involving electric
Do not use compressed air
6 months or
1000h
X
85