Evb Operation Procedures; Turn On The Module; Communication Via Usb - Quectel RG500L EVB User Manual

5g module series

Table of Contents

EVB Operation Procedures

This chapter introduces how to use the RG500L EVB for the testing and evaluation of Quectel 5G

RG500L Series QuecOpen module.

1. Insert the module TE-A to the EVB via connectors J0101 and J0102.

2. Insert two (U)SIM cards into the (U)SIM1 card connector (J0901) and (U)SIM2 card connector (J0902)

respectively on EVB.

3. Use RF cable to connect the module TE-A to the EVB, and connect antennas to the EVB.

4. Connect the EVB to a 12 V/ 3 A power supply, and then switch S0203 to ON. Then D1205 (ON/OFF

indicator of the module's power supply) will light up.

5. Press S1202 (PWRKEY) for at least 500 ms, then the module will be powered on and D1207

(indicating the module's operation status) will light up.

Power on the module according to the procedure in Chapter 4.1.

Connect the EVB with a PC through USB Type-C interface using the USB cable, and then run the

driver disk on the PC to install the USB driver. For details about USB driver installation, see

document [1]. The USB port numbers can be viewed in Device Manager of the PC after the USB

driver is installed, as shown below.

Figure 26: USB AT Ports Loaded on PC Device Management

Run the QCOM tool provided by Quectel on PC to realize the communication between the module

and the PC.

RG500L_EVB_User_Guide

5G Module Series

34 / 38

Table of Contents