Setting Of Adjustment Frequency For Analogue Secondary Clocks; Setting Of Impulse Width; Setting Of Analogue Lines - WEMPE 20097/W Operating Instructions Manual

WEMPE digital main clock 20097
Operation

6.2.2 Setting of adjustment frequency for analogue secondary clocks

If the local time is modified, the time of the analogue secondary clocks is automatically
adjusted within short. The standard setting of the main clock is 4Hz (4 impulses per second).
Setting of the adjustment frequency:
1. Remove write protection ( 6.2.1).
2. Press the key 1 several times until
the message on the right appears on
the display:
3. Press the ENTER key for confirmation. The cursor starts flashing.
4. Press the key 1 or 2 to modify the set value gradually.
5. Press the ENTER key to confirm the modification.
To cancel the modification, press the MENUE key twice.
6. Press the MENUE key to return to the time display.

6.2.3 Setting of impulse width

The default setting upon delivery of the impulse width of the analogue lines is ¼ s (pulse
width of the output impulse = 250ms). If a higher adjustment frequency than 1/impulse width
is set, the main clock automatically limits the maximum pulse width.
Setting of the impulse width:
1. Remove write protection ( 6.2.1).
2. Press the key 1 several times until
the message on the right appears on
the display:
3. Press the ENTER key for confirmation. The cursor starts flashing.
4. Press the key 1 or 2 to modify the set value gradually.
5. Press the ENTER key to confirm the modification.
To cancel the modification, press the MENUE key twice.
6. Press the MENUE key to return to the time display.

6.2.4 Setting of analogue lines

Two analogue lines are available:
LT: local time secondary clocks
SE: seconds secondary clocks
UT: UTC secondary clocks
f: forwards running
fb: forwards and backwards running
M: minutes (or seconds) impulses
H: ½ minute (½ second) impulses
G: GORGITIME / 24-hour display
26
V3.2a 05/2015