Mitsubishi Electric CR750-D Series Instruction Manual page 104

10 Maintenance of robot program
M_TrkArcEnc
[Function]
Refer to the encoder value which accumulated after a sensor reacts to a workpiece.
[Format]
[Referencing]
<Numeric value> = M_TrkArcEnc(<Condition number>)
[Terminology]
<Condition number [Integer]>: (can be omitted.)
Specify the tracking condition number.
Setting range: 1 to 8
If the argument is omitted, 1 is set as the default value.
< Numeric value [Long-precision real number]>
Return the encoder value which accumulated after a sensor reacts to a workpiece.
[Reference Program]
MLimit = M_EncStop(1) – M_EncSensor(1)
Def Act 1, M_TrkArcEnc(1) > MLimit Goto *S91STOP
・・・・・
Act 1 = 1
[Explanation]
(1) You can check the encoder value which accumulated after a sensor reacts to a workpiece.
(2) You can omit the step to specify <Condition number>.When it is omitted, condition number will be treated
as "1."
(3) Error L.3110 (value of the argument outside of the range) occurs when <Condition number> is outside a set
range.
10-94 MELFA-BASIC V Instructions
' the encoder value which accumulated after a sensor
reacts to a workpiece is calculated
' The definition which interrupts if the termination
location is exceeded
'Interrupt enable