B. Braun Vista basic Service Manual page 6

Z Important Information on this Manual
ISO 9000 ff/EN 46 000 ff
Repair and Inspection only
by Trained Technicians
Spare Parts and Test Equipment
Setting Off
B. Braun is certified in accordance with DIN ISO 9001 and DIN EN
46 001. This certification also includes maintenance and service.
The Vista basic complies with the IEC/EN60601-1 and
IEC/EN60601- 2-24 standards and is certified with the CE label ac-
cording to the EC directive 93/42/EC.
Training may only be performed by B. Braun. The possession of the
manual does not authorize the performance of repairs. The in-
structions on electrostatic sensitive components (ESD standards)
must be observed.
An electrical check must be performed following each repair (see
"Checks after Repair" bg. 5-1).
Only use original spare parts from the manufacturer. Do not
tamper with assembly groups which can only be exchanged
completely. The spare parts required are listed in the repair
instructions, '
The inspection personnel is responsible for the calibration of the
test equipment. Original test equipment can be calibrated at the
works of B. Braun. Further information is available upon request.
Additional notes and warnings are set off as follows:
Gives additional or special notes on information and working
steps.
E FES
Is used for working steps which may result in damage to the unit,
system or to a connected device.
IS USED FOR WORKING STEPS WHICH MAY RESULTIN PERSONAL
INJURY.
Vista basic 950971 Rev A (5/04)