Advertisement
4. Adding Rhythm
The Auto Rhythm feature automatically produces various rhythm patterns.
AUTO RHYTHM
1 Choose a rhythm pattern.
With HE-8, if you will not be using the USER patterns 1 and 2 on the right side, make
sure that their buttons are turned off. If a USER button is on, the selected pattern will
not be sounded.
ЕТЕ RHYTHM
AUTO RHYTHM.
dëi бшп
SING SAMBA um т
E =,
Vë
dei
SWAG SAMBA dw вби
xb cwm CODD
DEODÓÉdUIOdAa
POSÓDODo
TANGO
BALLAD
de
LATIN
ur
8 BEAT.
Ve
BEAT.
e
=
TANGO
BALLAD
E
uth
E»
Tan — 'GBEAT — SALSA. ES
DODÓÉDOOa
DÓDÓDODa
[HE-8]
[HE-6]
2 Set the volume level.
The volume can be set to one of five levels.
MAX
COI
(Maximum)
Cot = (Moderately high volume)
CU
(Medium volume)
CU
(Moderately low volume)
ON
(No sound is produced)
MIN
3 Set the tempo.
TEMPOHOATA)
When the TEMPO control is turned
to the right, the displayed value
Increases and the tempo speeds up
(maximum: 240).
When
turned
to
the
left,
the
displayed value decreases and the
The tempo you set appears on the TEMPO display. (The displayed values correspond
to the numbers of a metronome.)
4 Turn the rhythm on.
INTRO, эси
START
ENDING
20
SYNCHRO START
If you press this button instead of
the START button, the rhythm will
wait for you to press either a lower
or pedal keyboard note and then wili
begin from the first beat. This fea-
ture is handy when you plan to play
the accompaniment using the Auto
Bass
Chord
or
Arpeggio
Chord
feature.
When this button is tumed on, the
rhythm starts immediately. To stop
the rhythm, press this button again.
[TEMPO Lamp]
This lamp is located between the PERCUSSIVE/
ARPEGGIO CHORD section and the BALANCE
section. lt flashes in time with the tempo that has
been set by the TEMPO Control.
TEMPO
e Once the rhythm has been started:
The lamp will flash at the first beat (downbeat)
of each measure. Check this lamp when you
wish to start your performance in time with the
rhythm.
@ When the SYNCHRO START button is on
but the rhythm has not been started yet:
The lamp will flash at every fourth quarter
note. Before starting your performance, use this
lamp as a silent visual metronome. (The lamp
also functions in a similar manner while the
rhythm is stopped by the Foot Switch.)
[User Patterns] (HE-8 only)
For the two grey buttons labelled USER | and
USER 2 on the right side of the HE-8s AUTO
RHYTHM
section, the below
preset rhythm
patterns are provided.
User Pattern No.
1
2
Rhythm Pattern
WALTZ
Name
VARIATION | '& BEAT 1
When PACK data is transferred to the Electone,
however, USER patterns 1 and 2 may be replaced
by other rhythm patterns. (page 25)
[Using a User Pattern] (HE-8 only)
If a USER pattern is chosen on HE-8, any Fill In
and Intro/Ending patterns as well as Arpeggio
Chord (or Auto Bass Chord) patterns being used
for your performance will be synchronized with
the preset
pattern corresponding to the currently
lit lamp. Therefore, if you wish to produce an
automatic
the preset
performance using a User pattern, set
pattern as follows:
, User Pattern 1
= Сх (МАХ
30: VARIATION)
си
User Pattern 2
(16-BEAT 1)
co
B
il
bar
a
Lë
[Additional Information]
@Since Synchro Start enables the rhythm and
accompaniment to be started at the same time,
it is very convenient when playing accompani-
ment using Auto Bass Chord. (™page 20)
Advertisement
