Before Starting The Pump - Ismatec MasterFlex IPC 45 RPM Operating Manual

Section 2: Basic Setup & Settings

BEFORE STARTING THE PUMP

CAUTION: To avoid injury from the pump rollers, ensure all cassettes are loaded onto the
pump to cover the rollers before operation.
CAUTION: Do not block the rear panel of the pump. The power switch must always be
!
easy to access and the power supply must always be easy to disconnect.
CAUTION: Turn the pump off before removing or installing cassettes and tubing. Fingers
or loose clothing could get caught in the pump rollers.
CAUTION: The power supply provided with your pump meets the requirements of the
!
country where you purchased the pump. If you use the pump in another country, you must
use a power supply that meets the requirements of that country.
CAUTION: To avoid electrical shock, the power cord protective grounding conductor must
be connected to ground. Not for operation in wet locations as defined by EN61010-1.
• The cassettes cover the pump rollers. Ensure all cassettes are loaded into the pump channels before
operating the pump (NOTE: Cassettes can be loaded without tubing to ensure that all the pump rollers
are covered).
• Ensure the pump is mounted on a flat surface.
• Ensure adequate air flow around the pump and ensure that the ambient air temperature does not exceed
104° F (40° C).
2-3 Masterflex Ismatec Multichannel Peristaltic Pumps
® ®
Screen Lock
Scroll Down
Scroll Up
Settings
Start
Stop
Time Mode
Tube Life Timer
Tube Life Timer Expired
Update Available
User
User Access Level
Volume Mode
Wi-Fi