Peavey DPM V3 Owner's Manual page 85

EXPOSURE TO EXTREMELY HIGH NOISE LEVELS MAY CAUSE A PERMANENT HEARING LOSS. INDIVIDUALS VARY CONSIDERABLY IN SUSCEPTIBILITY TO NOISE INDUCED HEARING LOSS, BUT NEARLY
DANGER
EVERYONE WILL LOSE SOME HEARING IF EXPOSED TO SUFFICIENTLY INTENSE NOISE FOR A SUFFICIENT TIME.
THE U.S. GOVERNMENT'S OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION (OSHA) HAS SPECIFIED THE FOLLOWING PERMISSIBLE NOISE LEVEL EXPOSURES:
SOUND LEVEL dBA, SLOW RESPONSE
DURATION PER DAY IN HOURS
*
or less
ACCORDING TO OSHA, ANY EXPOSURE IN EXCESS OF THE ABOVE PERMISSIBLE LIMITS COULD RESULT IN SOME HEARING LOSS.
EAR PLUGS OR PROTECTORS IN THE EAR CANALS OR OVER THE EARS MUST BE WORN WHEN OPERATING THIS AMPLIFICATION SYSTEM IN ORDER TO PREVENT A PERMANENT HEARING LOSS IF
EXPOSURE IS IN EXCESS OF THE LIMITS AS SET FORTH ABOVE. TO INSURE AGAINST POTENTIALLY DANGEROUS EXPOSURE TO HIGH SOUND PRESSURE LEVELS, IT IS RECOMMENDED THAT ALL
PERSONS E?
this product,
2. All satety and operating instructions should be retained
for future reference,
3. Obey all cautionsin the operating instructions and on the
back of the unit,
4. All operating instructions should be followed.
S. This product should not be used near water, ie. a
bathtub, sink, swimming pool, wet basement, etc.
6. This product should be located so that its position does
not interfere with its proper veni , It should not be
placed fiat against a wall or placed in a built-in enclosure.
that will impede the flow of cooling alr.
7. This product should not be placed near a source of heat
such as a Stove, radiator or another heat producing
amplifier.
ylo a power supply O F F
" Unit adjacent to the power Supply
Never break off the ground pin on the power supply cord.
For more information on srgunding ig write for our free
booklet "Shock Hazard and Grounding,"
Power supply cords should always be handled caretully.
Never walk or place equipment on power supply cords.
Periodically check cords for cuts or signs of stress,
especially at the plug and the point where the cord exits
the unit.
- The power supply cord should be unplugged when the
unit ís to be unused for long periods of time.
. I this productis to be mounted in an equipment rack, rear
support should be provided.
105
110
ns
p rag. ny!
covering used on some units can be cleaned with a dam
rag, or an ammonia based household cleaner if
necessary.
Care should be taken so that objects do not fall and
liquids are not spilled into the unit through the ventilation
holes or any other openings.
. This unit should be checked by a qualified service
technician if:
A. The power supply cord or plug has been damaged.
B. Anything has fallen or been spilled into the unit,
C. The unit does not operate correctly.
D. Theunithas been dropped or the enclosure damaged.
. The user should not to attempt to service t h i s equipment,
AII service work should be done by a qualified service
technician,