Peavey DPM V3 Owner's Manual page 18

11.
12.
upper left corner).
. Press the right Arrow until the C (channel) parameter flashes. Select the
desired MIDI channel for the first program of the Multi.
. To adjust the program volume, press the Right Arrow again so that the
Vol parameter flashes. Higher values give higher volumes.
. To assign the program output, press the Right Arrow again so that the P
parameter flashes. Select the program's stereo output jack pair (1+2,
344, or 546).
. To assign a particular program to Multi, press the Right Arrow until the
Prog parameter flashes. Select the desired program.
. Press the Right or Left Arrow until the C (channel) parameter flashes.
Select the desired MIDI channel for the second program of the Multi.
Assign the next program to the Multi in a manner similar to steps 7-9.
Select additional Multi programs in a manner similar to hów the first and
second programs were selected: select the channel, volume, output,
and program. Limit yourself to four programs or so for now.
As you become more familiar with the DPM V8, you'll probably want to pro-
gram setups for Multis 2-4 as well.
1.4c The Payoff!
1. You're almost ready to play either your keyboard or sequencer and hear
the DPM V3 in action.
Press the Prog master button.
2.
3.
The display will show the last program selected (in a "virgin" DPM V3,
program 000).
If you selected Omni or Poly mode (not Multi), check out the various pro-
grams by selecting them and playing your keyboard or sequencer. The
display will show an eighth note for each voice in use as you play, thus
confirming that the DPM V3 is receiving and understanding MIDI data. If
no notes show up in the display:
* Check your cabling.
* Check the MIDI channel assignments on your sequencer/master con-
troller and the DPM V3.
If you don't hear any audio:
* Make sure you're using the right output connections. Try different out-
puts if the problem persists.
* Check that the amplifier is on and the mixer volume turned up.
e Make sure the DPM V3's front panel volume control is turned up.
. If you selected Multi mode, audition various programs by selecting the
desired Multi and changing programs (see step 9 in section 1.4b).
19