Peavey DPM V3 Owner's Manual page 14

output assignments. A program can be assigned to two outputs for stereo opera-
tion, but, also, more than one program can be assigned to the same output. This
is useful if you have, for instance, two different bass sounds on two different chan-
nels where one plays in the chorus and another in the verse. Assigning both bass
sounds to the same output frees up other outputs for other sounds.
The diagram below shows a typical sequencer-based setup that provides in-
dividual stereo outputs for three different sounds. Each of the sounds feeds its
own pair of mixer input jacks. For more information on using the output structure,
see the section on advanced applications.
Sequencer
MIDI out
sub 1
sub 2 main
PA OF PA
MIDI out thru
to MIDI in
of other modules
© eo VO
audio inputs
Mixer
MIDI: Run a MIDI cable from the sequencer's MIDI out to the DPM V3's MIDI
in. To drive additional tone modules from the same sequencer, patch the DPM V3
MIDI thru output to the next tone module's MIDI in. Patch the second module's
thru into an additional module's MIDI in, and so on. Caution: Do not attempt to
connect more than threé or four units together using thru connections, as this may
15