Peavey DPM V3 Owner's Manual page 28

Note: The pan position can also be modulated by two different modulation
sources. If the pan position is being modulated, then that will also affect the stereo
position as well as any changes you make in the Pan page.
1. Assuming you're in the Edit menu, select the OUT Vol/Pan/Bend page.
2. Press the Right Arrow button until the Pan parameter flashes.
2.3g Set Pitch Bend Range
pitch by a whole tone, and rotating the pitch bend wheel all the way toward you
will decrease the pitch by a wholé tone.
1. Assuming you're in the Edit ménu, select the OUT Vol/Pan/Bend page.
2. Press the Right Arrow button until the Bend parameter flashes.
3. Select the desired bend amount: (OFF, HALF, WHOLE, M3RD (minor third),
THIRD (major third), 4TH, DM5TH (diminished or flatted fifth), and FIFTH.
2.4 INITIALIZE ENTIRE UNIT
Remember — any patches will be lost during initialization! Back up the factory pat-
ches when you first receive your DPM V3 and save your work often so that if you
ever do need to initialize, your edits will not be lost.
To initialize:
1. Turn the power off (if it's on) and wait 15 seconds or more.
2. Hold both the PROG and Right Arrow buttons down while turning on power.
3. Continue holding down the buttons until the display shows P000 *Initialized*.
2.9