Advertisement
iNSTRUCTiONS
FOR TRACTORS WITH DUAL
FRONT DECK SUSPENSmON BRACKETS
STEP 4: (SEE FIGURE 4)
Compare your tractor to the illustrations shown Jn
figure 4. If your tractor resembles the top illustration,
go to step 5. If your tractor resembles the bottom
illustration, go to step 7.
TYPE A
\
FRONT SUSPENSION
BRACKET
BRACKET
STEP 6: (SEE FIGURE 6)
Attach the R.H. hanger bracket to the two front empty
holes on the right side of the tractor frame using two
new 3/8" x 1" hex bolts (D), 3/8" lock washers (L), and
3/8" flat washers (N) as shown. For the rear hole, use
a 3/8" x 1" hex bolt (D), 3/8" lock washer (L) and 3/8"
flat washer (N) with a large 1/2" washer (M) placed
between the hanger bracket and the tractor frame.
Tighten.
Repeat for the left side.
,
Skip to step 9.
3/8" FLAT
WASHER(N)
318"LOCK
WASHER
(L)
3/8" x 1"
X
\
REX BOLT
(D)
1/2" LARGE
WASHER (M)
\
R.H. HANGER
BRACKET
FtGURE 6
FIGURE 4
iNSTRUCTiONS
FOR TYPE A TRACTORS
STEP 5: (SEE FIGURE 5)
Remove any bolts found in the holes indicated in the
illustration.
REMOVE BOLTS FROM THESE HOLES
FIGURE 5
FRONT
SUSPENSUON
BRACKET
iNSTRUCTiONS
FOR TYPE B TRACTORS
STEP 7: (SEE FIGURE 7)
Remove any botts found in the holes indicated in the
illustration.
REMOVE
BOLTS
FROM
THESE
HOLES
FRONT
SUSPENSION
BRACKET
FIGURE 7
Advertisement
