Table of Contents
Advertisement
Push the inner panel in at the top (fig.
3.
Slide the outer panel back in and make sure that it is
4.
sitting correctly at the bottom in the retainer (fig.
Push the outer panel in at the top (fig.
5.
Put the cover back in place and press on it until you
6.
hear it click into place (fig.
Open the appliance door again fully.
7.
Close the two locking levers on the left and right
8.
(fig.
)
'
Close the appliance door.
9.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
).
#
$
).
%
).
&
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
).
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 31
Fault
The appliance is
not working.
The appliance will
prompt you again
to perform initial
start-up.
The settings on
the appliance
cannot be config-
ured. A key sym-
bol has lit up on
the display or
†'"".
The appliance is
not heat-
ing."Demo mode"
is shown on the
display.
--------
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault messages on the display
If a fault message (begins with "E") appears on the
display, e.g. E0502, touch the v button. This will reset
the fault message.Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the fault message appears
again, call our after-sales service and quote the exact
fault message and the E no. of your appliance.
~ "Customer service" on page 27
Trouble shooting
Possible
Notes/remedy
cause
Defective cir-
Check the circuit breaker in the
cuit breaker.
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
Power failure. Perform initial start-up again.
The child-
Deactivate the childproof lock by
proof lock is
pressing and holding the button
activated.
with the key symbol for approx. 4
seconds.
Demo mode
Briefly disconnect the appliance
is activated.
from the mains (switch off the cir-
cuit breaker in the fuse box) and
then deactivate demo mode in the
basic settings within approx.
5 minutes.
en
25
Advertisement
Table of Contents
