HEIDENHAIN TNC 150 B Mounting Instructions page 4

These Mounting and Interface Instructions are valid for the following control versions:
TNC 150-Versions with interface for an external machine PLC
Transducer inputs: Sinusoidal signals Transducer inputs: Square-wave signals
TNC 150 B TNC 150 BR
TNC 150 F (with 3D-Movement) TNC 150 FR
TNC 150-Versions with PLC-board(s)
Transducer inputs: Sinusoidal signals
TNC 150 Q
Transducer inputs: Square-wave signals
TNC 150 QR
TNC 150 W (without 3 D-Movement)
TNC 150 WR
1. General information
The HEIDENHAIN TNC'150 is equipped with an integral PLC: and is available in two basic versions:
HEIDENHAIN TNC 150 B
Control with a standard output to the machine interface.
The standard PLC program which is contained in the TNC 15C1 almost corresponds to the interface for the
TNC 145 control version. Alterations to this interface are possible (if required, please ask for the PLC-Description
HEIDENHAIN TNC 150)
HEIDENHAIN TNC 150 Q
Control with a PLC-power board PL 100 B having
.63 inputs, 9 of which have fixed allocations,
.31 outputs
or with PLC-power board PL 110 B having
.63 inputs, 9 of which have fixed allocations
.25 outputs,
.3 bipolar output pairs
On delivery, this control version also has the standard PLCprogram stored.
By using a further PLC-power board PL 100 B or PL 110 B the PLC-inputs and outputs may be doubled.
Both control versions permit the connection of the visual display units BE 111 (9" screen) or BE 211
(12" screen).
Caution!
The description for the functioning of the interface being deal-: with pertains to the control versions
HEIDENHAIN TNC 150 B and HEIDENHAIN TNC 150 0. This is valid if the stored PLC-standard program has
not been altered prior tr) delivery.
Please note:
We are constantly working on the further development of our TNC-Controls and a certain control may deviate
from the versions described within this manual.
4