Toro 39521 Operator's Manual page 57

8. Start the engine and move the throttle midway
between the S
LOW
9. Disengage the parking brake.
10. Slowly move the motion-control levers in the
forward and reverse directions 5 to 6 times.
Note:
Cycling the traction-controls forward and
reverse purges air from the transmissions.
11. Shut off the engine and remove the key.
12. Check the fluid level in the expansion tank,
and add the specified fluid as required; refer to
Checking the Transmission Fluid Level (page
55).
13. Repeat steps 8 through
completely purged from the transmissions.
Note:
The air is purged when the transmissions
when the transmissions operate at normal noise
levels and smoothly move forward and reverse
at normal speeds.
14. Lower the machine and remove the jack stands.
15. Reset the transmission-oil maintenance
reminder; refer to
Maintenance Reminder (page
Resetting the Transmission-Oil
Maintenance Reminder
1. Prepare the machine for maintenance; refer to
Preparing the Machine for Maintenance (page
34).
Note:
You must engage the parking brake to
reset the maintenance reminder.
2. Cycle the key switch between the
and the position 6 times within 8 seconds.
OFF
The Service Transmission screen displays and
flashes (Figure 71).
Service Transmission Screen
3. Press down the multi-function switch.
The transmission-oil maintenance reminder
resets to 250 (hours), exits the service
and F positions
AST
12 until all the air is
Resetting the Transmission-Oil
57).
RUN
Figure 71
transmission screen, and returns to the default
screen.
Note:
You can exit the service transmission screen
at any time by turning the key to either the OFF or
the START positions.
position
g212118
57