Table of Contents
Advertisement
7.
Apply a thin coat of specified fluid onto the seal
of the new transmission filter.
8.
Install the filter by rotating it clockwise onto the
filter adapter until the seal contacts the base of
the adapter, then tighten the filter an additional
3/4 to 1 turn
(Figure
9.
Install the filter guard with the 3 washer-head
bolts (1/4 x 3/4 inch) that you removed in step
(Figure
68), and tighten the bolts to 1117 to 1243
N∙cm (90 to 110 in-lb).
Filling the Transmissions with
Fluid
Service Interval: After the first 100 hours
Every 250 hours thereafter
1.
Raise the rear of machine up and support with
jack stands (or equivalent support) just high
enough to allow the drive wheels to turn freely.
CAUTION
Raising the machine for service
or maintenance relying solely on
mechanical or hydraulic jacks could be
dangerous. The mechanical or hydraulic
jacks may not be enough support or may
malfunction allowing the machine to fall,
which could cause injury.
Do not rely solely on mechanical
or hydraulic jacks for support. Use
adequate jack stands or equivalent
support.
2.
Align a drain pan under the sight plugs of the
transmissions
(Figure 69
68).
and
Figure
70).
3
Left transmission shown
1. Sight plug
2. Sight-plug port
Left transmission shown
1. Sight plug
2. Sight-plug port
3.
At the inboard side of the transmission, near
the top, remove the sight plug from 1 of the
transmissions
4.
Add the specified fluid to the expansion tank
until fluid flows from the sight-plug port; refer to
Checking the Transmission Fluid Level (page
55).
5.
Install the sight plug and torque it to 244 N∙m
(180 in-lb).
6.
Repeat steps
transmission.
7.
Add the specified fluid into the expansion tank
until the fluid level is at the Full Cold line of the
tank.
56
Figure 69
3. Up
Figure 70
3. Up
(Figure 69
and
Figure
3
through
5
for the other
g026015
g026016
70).
Advertisement
Table of Contents
