Toro 39521 Operator's Manual page 14

There are 2 ways to activate the display:
1. Tap the multi-function switch either up or down
to display the tine-engagement meter.
2. Step on the tine ground-engagement foot switch.
A higher number on the status bar increases the
length of the aeration plug and a lower number
decreases it.
Note:
If the plug length is not desired length, the
machine may need to be adjusted to accommodate
for the weight of the operator; refer to
Weight-Adjustment Control (page 14)
information.
LED Status Lights
Located on the right side of the hour
meter/tine-engagement display.
The LED is multi-colored to indicate the system status
and is located on the right side of the panel.
•
Solid green—indicates normal operating activity.
•
Blinking red—indicates a fault is active.
•
Solid red—indicates maintenance is required.
Tines Ground-Engagement Foot
Switch
The switch is located on the operator platform
8).
To lower the tines into the ground, stand on the tine
ground-engagement switch. The LED illuminates in
the hour meter/tine engagement display when the tine
engagement is activated. To raise the tines, remove
your foot from the switch.
This switch can be disabled with the multi-function
switch.
•
Tap and hold the bottom of the switch to override
and disable the foot switch. The LED illuminates in
the hour meter/tine engagement display. Use this
feature when transporting the machine.
•
To unlock, tap and hold the top of the multi-function
switch until the LED light disappears.
Note:
The disable feature is engaged each time you
shut off the engine.
Key Switch
The key switch is located on the right side of the
control console
Use the key switch to start and shut off the engine.
The switch has 3 positions: O
(Figure
Operator
for more
1. O
2. O
Operator Weight-Adjustment
Control
Located on the left side of the control console
8).
This feature takes into account the weight of the
operator so that the correct aerating pressure and plug
length is achieved and to maximize lateral machine
(Figure
stability. Rotating the control counterclockwise
decreases the pressure and rotating it clockwise
increases it;
Setting (page
Note:
so that the drive tires lightly touch the ground.
Important:
all times to maximize lateral machine stability.
Multi-Function Switch
Located to the left of the hour meter/tine-engagement
display.
This switch allows you to do the following:
•
Increase/decrease the depth of an aeration plug.
•
Lock or unlock the tine-depth setting.
•
Lock or unlock the tine ground-engagement foot
switch.
14
(Figure 8).
11).
Figure 11
3. S
FF
N
Adjusting the Operator Weight Control
25).
Each operator must adjust the system pressure
Keep the drive tires on the ground at
, O , and S
FF N TART
g008610
TART
(Figure