Chapter 6: Imagepass-P1 Set-Up - Canon imageRUNNER ADVANCE C5560 Configuration And Installation Manual

Chapter 6: imagePASS-P1 Set-up

This section will guide you through the setup of the imagePASS-P1 to meet the FedEx
Office Standard configuration. All files for this section can be obtained from the Canon
e-Support site under the Major Accounts section > New MFP Deployment.
Note: A reference configuration page with highlighted yellow sections showing FedEx
Office settings is included at the end of this document. It can be used to compare the
configuration after engine and controller setup are completed.
Note: The IP address obtained in Chapter 5 will be used to configure the controller.
The Subnet mask and gateway will be identical to the machine being replaced.
Important : When performing an update or overwrite utilizing the Fiery clone process,
the paper catalog must be removed prior to re-installing the catalog or updating to a
newer version. The steps in section "Unregister all Custom / Plain Media from Auto
Correct Color Tone" must be followed before attempting to remove or reload the
catalog.
Preparing the USB drive for the FedEx Office Clone image
Note: Due to the size of the imagePASS clone image, it is strongly recommended
that you prepare the USB drive before going on site to perfom installation.
Before you begin, please make sure you have the following items:
o USB Drive (Minimum 16 GB) – not provided
o Fiery USB Setup tool for System Software
(FieryUSBSetupTool_v2.0.25.zip)
o Fiery Clone Tool for FedEx Office
(FCTe-3.1.iso.zip)
o FedEx Office imagePASS-P1 Clone Image
(FXO_C5500_P1_Clone_12082017.zip)
o FedEx Office Paper Catalog file
(FXO_C5500_PaperCatalog_12082017_v2.zip) – from support.cusa.canon.com
19
imageRUNNER ADVANCE C5560 with imagePASS-P1 Full Service Configuration and Installation Guide
– from support.cusa.canon.com
– from support.cusa.canon.com
– from support.cusa.canon.com