Canon imageRUNNER ADVANCE C5560 Configuration And Installation Manual page 27

Network Setup
Power-up and verify that the imagePASS-P1 connects to the engine, then proceed with
setup. Once enabled and the imagePASS-P1 is detected by the engine, the Fiery icon
will appear on the Main Menu of the Canon User Interface. It may take up to 7
minutes for the imagePASS-P1 to boot and be detected by the engine.
The network settings will be configured in this step. Using the Canon UI and Fiery
Button follow the steps below to access the network configuration. The remaining
configuration settings of the imagePASS-P1 will be configured using Command
Workstation in Configuring Manual Fiery Settings section.
1. Press the Fiery Button as shown above
2. Press Tools  Setup  enter password [Fiery.1]  [Login]
3. Press Network  IPv4  uncheck [Get IP address automatically]  Enter [IP address],
[Subnet Mask] and [Gateway] as explained in Chapter 5.
Note : The subnet mask of all printers in a FedEx Office center should match what
is configured on their other printers. If there are any questions regarding the
network configuration, a FedEx Office Center Manager or Field Technology
Specialist should be consulted.
4. Uncheck [Get DNS address automatically] then enter
[Primary DNS]  192.112.46.53 and [Secondary DNS]  enter 192.112.46.153.
5. Uncheck [Use WINS]
6. Scroll up, select [Save Changes]
7. Press [Exit Setup]  [Reboot Now]
8. The controller will come to an idle state within 7 minutes. Once idle, proceed to
the next section.
27
imageRUNNER ADVANCE C5560 with imagePASS-P1 Full Service Configuration and Installation Guide