Canon ImagePRESS Server H350 V2 Service Manual page 85

8. In Warning window, click Continue.
The Network connection is lost and "Fiery services are not responding" message is displayed on the printer control panel.
NOTE:
It may take approximately 40 minutes or more to format the USB flash drive and load the files on to the drive. Do not interrupt the
operation.
9. When the "Remove all USB Drives except the drive for the backup image" message is displayed, remove the first
USB flash drive (32GB) and attach the second USB drive (preferably 64GB) to one of the USB3.0 ports on the
imagePRESS Server and click Continue.
The Fiery deployable image of imagePRESS Server is loaded into the second USB flash drive and the imagePRESS Server
enters into an unusable state.
NOTE:
It may take approximately 60 minutes or more to load the files on to the drive. Do not interrupt the operation.
■ To install the imagePRESS Server using a Fiery deployable image
Before you restore the imagePRESS Server with a Fiery deployable image, you must do the following:
• Create a bootable USB storage device with the Fiery deployable image
• Connect a monitor, keyboard, and mouse to the imagePRESS Server
NOTE:
You can also use this procedure to install the system software after you replace the HDD with a new one.
1. Shut down the imagePRESS Server
2. Attach the bootable USB backup media with the Fiery deployable image (which was created using
deployable image" on page
Make sure to remove any media in the DVD drive. Do not attach other USB devices to the imagePRESS Server.
3. Press the power button to turn on the imagePRESS Server.
The imagePRESS Server will boot from the bootable USB backup media.
4. When the "Insert media for this backup" message is displayed in the imagePRESS Server, remove the first (bootable)
USB flash drive and attach the second USB drive with Deployable image to one of the USB3.0 ports on the
imagePRESS Server.
After restoring the imagePRESS Server using Fiery deployable image, the imagePRESS Server will display IDLE.
5. Restore the imagePRESS Server using the backup image that was created in Step 1 of
on page 77.
77) to one of the USB3.0 ports on the imagePRESS Server.
5. PERFORMING BACKUP AND RESTORE
78
"To create a
"To create a deployable image"