Canon ImagePRESS Server H350 V2 Service Manual page 43

2. Release the six tabs and pull the front bezel off.
No.
1 Top tab (one on each side of bezel)
2 Middle tab (one on each side of bezel)
3 Bottom tab (one on each side of bezel)
■ To replace the chassis panels
1. Attach the front bezel to the front of the unit snapping tight the six tabs. See
2. Insert the anchor screw to secure the front bezel. See
3. Slide the right chassis cover into place and secure with two screws on backside of the unit.
4. Slide the left chassis cover into place and secure with two screws on backside of the unit.
■ Fiery QuickTouch display module
Fiery QuickTouch is attached to the top panel of the imagePRESS Server.
Follow the directions to remove the chassis covers. See
the side covers, then the front cover before you will be able to release the top bezel with the Fiery QuickTouch attached.
Figure 25: Front bezel tabs
ITem
"To remove the front panel" on page
"Opening the imagePRESS Server" on page
36
4. REPLACING PARTS
1
2
3
"To remove the front panel" on page
35.
34. You will need to remove
35.