Backup Recommendations - Canon ImagePRESS Server H350 V2 Service Manual

Backup recommendations

Even though the server maintains a backup you can use for recovery of the factory installation, creating a separate backup
provides the ability to retrieve customized settings and job information if a recent backup is needed. You can create a backup by
using Fiery System Restore (from Command WorkStation, WebTools, or Fiery QuickTouch), or Fiery System Installer.
• To create a backup using Command WorkStation, or from a a remote location using WebTools, see
configuration" on page
• To create a backup using Backup and Restore, see
• To create a backup using Fiery System Installer, see
When backing up an existingimagePRESS Server installation
• For an existing imagePRESS Server installation, first check if a backup image exists either on the server or an external
location.
• If a backup image exists, check if it is up to date. Compare the date stamp of the existing backup image to the date of
the last patch installation. See the System Update log for patch information. (See
80)
• If a backup image does not exist, create a new one after installing all available software updates.
• The backup image may be saved to or found in any of the following locations:
• Local Disk
• USB drive
• External hard disk
• Network
• If you do not have a backup with the system settings and jobs, the system can access a preinstalled recovery backup on the
hard disk drive provided with the imagePRESS Server. See
IMPORTANT:
If you restore the system using the pre-installed recovery backup, the system and configuration will be reset to the factory
default.
• If you have a system backup that includes your settings and jobs, you can restore the backup using Fiery System Installer
(see "Restore with Fiery System Installer" on page
68).
IMPORTANT:
Backed up data can be only restored to the same imagePRESS Server.
• Use a descriptive and consistent naming convention when saving image files (such as date, product name, product version,
and short description).
After creating a backup image file, it is recommended that you transfer the image file to an external location, such as a
network location or external drive.
IMPORTANT:
If you select USB storage device as a destination, all the existing data in the drive will be lost when you create a backup
on the USB storage device.
71.
5. PERFORMING BACKUP AND RESTORE
"Using Backup and Restore" on page
"Restore with Fiery System Installer" on page
"To restore the backup image" on page
74) or Fiery System Restore (see
67
"Backing up the system
68.
74.
"Installing system software" on page
70.
"Using Backup and Restore" on page