Canon ImagePRESS Server H350 V2 Service Manual page 48

2
No.
1 Switch (positioned to 1-3m)
2 Printer interface cable connector
3 PCIE x16 connector
● To remove the printer interface board
1. Shut down and open the imagePRESS Server (see
To remove the printer interface board, you must remove the left panel.
2. Remove the printer interface cable that connect the printer interface board and the printer.
3. Remove the board mounting bracket screw that attaches the printer interface board to the chassis.
4. Remove the printer interface board from the chassis.
Grasp the printer interface board at the front and back edges and gently pull the board straight out of its motherboard
connector.
5. Place the printer interface board in an antistatic bag.
● To replace the printer interface board
1. Insert the board into the PCIE x16 slot on the motherboard. (see
The printer interface board edge connector is keyed to fit in the motherboard connector only when properly oriented.
2. Secure the board to the chassis with the board mounting bracket screw that you removed earlier.
3. Reassemble the imagePRESS Server and verify its functionality. (see
functionality" on page
Motherboard
IMPORTANT:
If you are removing the motherboard in order to replace it with a new motherboard, review the roubleshooting and
motherboard cautions on
The CPU mounted on the motherboard controls the image data transferred to and from the printer interface board. The
motherboard also controls hard disk drive functions and the communication between the imagePRESS Server and external
devices.
1
3
Figure 26: Printer interface board
61)
"Replacing the motherboard" on page
Item
"Shutting down the system" on page
"Removing the motherboard" on page
"To reassemble the imagePRESS Server and verify
44.
41
4. REPLACING PARTS
33).
42)