Canon ImagePRESS Server H350 V2 Service Manual page 56

3. To release a DIMM, push outward on the levers on each side of the DIMM.
No.
1 Clips
2 DIMM
3 Slot notch
4. Pull the DIMM straight out of the socket.
5. To replace a DIMM, insert the DIMM straight into the socket and close the levers at each side to lock it into place.
NOTE:
The socket is keyed so that the DIMM fits only one way. (See the notches in the preceding figure.)
IMPORTANT:
Make sure that the entire length of the DIMM (ends and center) is fully seated in the socket and that the levers close securely
around the ends of the DIMM.
6. If you installed a new DIMM, make sure to reset the time and date in Setup. (see
on page 54)
7. Replace the printer interface board. (see
8. Reassemble the imagePRESS Server and verify its functionality. (see
functionality" on page
CPU
The CPU is installed in a socket on the motherboard. Before you remove the CPU from its socket, remove the motherboard from
the chassis (see "Removing the motherboard" on page
the cooling assembly from the imagePRESS Server (see "To remove the cooling assembly") The CPU cooling assembly consists
of a fan and a heatsink.
NOTE:
Do not remove the CPU fan from the heatsink.
1
Figure 28: Releasing a DIMM
"To replace the printer interface board" on page
61)
2
3
Item
"To reassemble the imagePRESS Server and verify
42) disconnect the CPU fan cable from the motherboard, and then remove
49
4. REPLACING PARTS
1
"To configure the system date and time"
41)