Installation; Installation Preparation - Redx RX Series User Manual

3.1 Installation Preparation

a. Not to be installed in direct sunlight. Product is designed for indoors. Vertical mounting only.
b. Install in a ventilated location. There must be enough clearance to ensure that the module
operates in the optimal heat dissipation state.
c. Install at suitable distance from any restricted areas, please review Standard ASNZS5139.
d. Install on a sturdy supported surface.
e. The location must fit the weight and size of the module.
f. The environmental temperature must be between -20℃ to +50℃, and the relative humidity
between 0% and 90% (without condensation)
g. Location shall be dry with adequate air flow (Pollution Degree < PD3）.
h. Installation is prohibited to in any of the following environments
high temperature
No direct sunlight
Direct sunlight
a.The minimum clearance on the sides must be maintained at least 300mm.
b.Installation location of the inverter should be easy for operator to turn off at any time.
c.Do not install the inverter near signal transmitters / antennas.
d.Do not install the inverter in the living area.
e.Do not install the inverter at location where children can easily access.
Rev 20230602
rain
No rain exposure
Rain exposure
Figure 3.1.1 - RX-5000AC Installation locations
erosion slope
RX - 5000AC
fire
No Snow Exposure
Snow Exposure
Page 17 of 40