Basic Safety Measures - HADEF 240/12 Installation, Operating And Maintenance Instruction

Type of drive
Not explosive atmosphere
Manually driven
Motor driven
) * At an atmospheric pressure range from 0.8bar to 1.1bar and an oxygen content of approx. 21%
) ** Devices of this category have been specially modified and labeled by the manufacturer
DANGER!
The permissible ambient temperature must not be exceeded!
The appropriate use of the hoists is vertical lifting and lowering of unguided loads. In combination with
trolleys, loads can also be moved horizontally.
DANGER!
The use is not allowed:
 for pulling loose of stuck loads, dragging of loads and inclined pulling.
 in explosive atmosphere, except the unit is especially modified for it and marked by an indication label.
 in reactor containment vessels.
 to transport people.
 The device is not suitable for use on stages and in studios.
Persons must not stand under a suspended load.
NOTICE!
If the units are not used appropriately, it is not possible to ensure safe operation.
The owner and operator have sole liability for all personal injury and damage to property arising from
inappropriate use.
2.5

Basic safety measures

 Observe installation-, operation and maintenance instruction.
 Take notice of caution notes at units and in the manual
 Observe safety distances.
 Take care for a free view on the load.
 Only use the hoists appropriately.
 The equipment is to be used exclusively for movement of goods. Under no circumstances my persons be
moved.
 Never load the devices beyond their working load limit.
 Pay attention to the accident prevention regulations (UVV).
 Should the hoist be used outside of Germany, please pay attention to the national regulations that apply.
 Supporting structures and load-attached devices used in conjunction with this equipment must provide an
adequate safety factor to handle the rated load plus the weight of the equipment. In case of doubt, consult
a structural engineer.
 If the equipment has not been used for a period of time, carry out visual checks of all main components
such as chains, load hooks etc. and replace any damaged parts with new, original spare parts before
putting the equipment back into operation!
 Do not use a hoist that is defective, pay attention to any abnormal noise it makes during operation.
 Stop working immediately in case of disturbances and remedy failures.
 Any damage and faults must be reported to a responsible supervisor immediately.
 If the unit is put into motion, any persons in the immediate vicinity must be informed by calling to them!
 Please pay attention to the regulations for load carrying devices UVV for both positive and non-positive
methods of attaching loads.
 The lifting tackle or the load must be securely attached to the hook and be seated at the bottom of the
hook.
5.52.145.00.01.05
Device classification for
-20°C/+50°C
-20°C/+40°C
Explosive atmosphere
according to ATEX
-20°C/+40°C
-20°C/+40°C
)* )**
5