Requirements For The Operating Personnel; Appropriate Use; Basic Safety Measures - HADEF 108/99 Installation, Operating And Maintenance Instructions For The Installer And The User

 The required personal protective equipment for the operators, service and repair personnel is available
and is used.
 The operating instructions are always available at the location where the equipment is used and that they
are legible and complete.
 The unit is only operated, serviced and repaired by qualified and authorized personnel.
 This personnel is regularly trained in all applicable matters regarding safety at work and environmental
protection, and that they are familiar with the operating manual and, in particular, the safety instructions it
contains.
 Any safety and warning signs on the devices are not removed and remain legible.
 customers equipment at site must comply with currently applicable ATEX-regulations
WARNING!
It is not allowed to make constructive changes of the equipment!
2.3

Requirements for the operating personnel

The units may only be operated by qualified persons that are appropriately trained and that are familiar with
it. They must have their employer's authorization for operation of the units.
Before starting work, the operating personnel must have read the operating and installation instructions,
especially the chapter "Safety Instructions".
This is especially important for operating personnel that rarely uses the equipment, i.e. for installation or
maintenance work.
DANGER!
In order to avoid severe injury, please pay attention to the following when using the equipment:
 Use protective clothes/equipment.
 Do not wear long hair hanging down open.
 Do not wear rings or other jewelry.
 Do not wear clothes that are too big/wide.
 Do not reach into ropes, chains, drive parts or other moving parts with your hands
2.4

Appropriate use

Devices are intended for deflecting a wire rope in all directions.
The permitted safe working load of the devices must not be exceeded! An exception can be made during the
load test before initial operation, carried out by a licensed qualified person.
 Defective devices and load suspension devices must not be used until they have been repaired! Only
original spare parts must be used. Non-compliance will result in any warranty claims becoming void.
 Liability and warranty will become void if unauthorized modifications of the units are made by the user!
 The permitted environmental temperature during equipment operation is –20°C up to +50°C.
DANGER!
The ambient temperature range must not be exceeded!
NOTICE!
If the units are not used as intended, safe operation is not guaranteed.
The operator alone is responsible for all personal injury and damage to property resulting from improper
use.
2.5

Basic safety measures

 Observe installation-, operation- and maintenance instruction.
 Pay attention to caution notes at units and in the manual.
 Observe safety distances.
 Take care for a free view on the load.
 Only use this devices appropriately.
4 5.52.624.00.01.01