Table of Contents
Advertisement
Cable routing for the power supply unit
Read this section to learn about cable routing for the power supply unit.
Figure 20. Cable routing for the power supply unit
Table 18. Cable routing for the power supply unit
From
Micro-fit to 1X15P and 1X4P Y-splitter power cable
1
(4-pin or 8-pin SATA connector for processor power)
Micro-fit to 1X15P and 1X4P Y-splitter power cable
2
(15-pin connector for system power)
and
are parts of the same Y-splitter cable.
Note:
1
2
Make sure to follow the "Cable routing guidelines" in
For the system-board connector locations, see
ThinkSystem ST50 V2 Maintenance Manual
28
To
Processor power connector
Note: The 2x2 pins marked in grey are for 300W PSU.
System power connector
"Internal cable routing" on page
"System board components" on page
19.
18.
Advertisement
Table of Contents
