Table of Contents
Advertisement
Attention:
• Read
"Safety inspection checklist" on page iv
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Memory modules are sensitive to static discharge and require special handling. In addition to the standard
guidelines of
"Handling static-sensitive devices" on page
• Always wear an electrostatic-discharge strap when removing or installing memory modules. Electrostatic-
discharge gloves can also be used.
• Keep each memory module separated from one another. Do not stack memory modules directly on top of
each other during storage.
• Keep the gold memory module connector contacts from touching anything.
• Handle memory modules with care: never bend, twist, or drop a memory module.
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
About this task
Step 1.
Locate the memory module slots and determine memory module installation order based on
"Memory module installation rules" on page
Step 2.
Make sure that both retaining clips on the memory module connector are in the open position.
a.
With the tip of a pointed tool, carefully press the retaining clips.
b.
Push the retaining clips outward on each end of the memory module slot.
Figure 90. Opening the memory module retaining clips
ThinkSystem ST50 V2 Maintenance Manual
114
and
.
"Installation guidelines" on page 41
43:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
44.
to ensure that you
Advertisement
Table of Contents
