Table of Contents
Advertisement
Figure 43. Removing drive cage from drive bay 1
After you finish
1. Install a new drive cage, see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the drive cage (bay 1-2)
Follow this procedure to install the bay 1 drive cage bay 2 drive cage.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read
"Safety inspection checklist" on page iv
work safely.
Watch the procedure
ThinkSystem ST50 V2 Maintenance Manual
60
"Install the drive cage (bay 1-2)" on page
and
"Installation guidelines" on page 41
60.
to ensure that you
Advertisement
Table of Contents
