Table of Contents
Advertisement
S035
CAUTION:
Never remove the cover on a power supply or any part that has this label attached. Hazardous voltage,
current, and energy levels are present inside any component that has this label attached. There are no
serviceable parts inside these components. If you suspect a problem with one of these parts, contact
a service technician.
About this task
Attention:
• Read
"Safety inspection checklist" on page iv
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
"Power off the server" on page
• If the server is in a rack, remove it from the rack. See
• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
Procedure
Step 1.
Make preparation for this task.
a.
Remove the server cover, see
Note: The heat sink and processor could be very hot. To avoid burning yourself, wait for a few
minutes after turning off the server before you remove the server cover.
b.
Remove bay 1 drive cage and bay 2 drive cage (if applicable), see
drive cage (bay 1-2) replacement" on page
Step 2.
Disconnect the power supply unit cable from the system board.
Step 3.
From the outside of the chassis, remove the four screws that secure the power supply unit to the
chassis.
ThinkSystem ST50 V2 Maintenance Manual
130
and
9.
.
"Remove the server cover" on page
"Installation guidelines" on page 41
"Remove the server from the rails" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
50.
to ensure that you
138.
144.
"Simple-swap drive and
Advertisement
Table of Contents
