Attaching The Battery Pack; Attaching The Beltclip - Uniden UH835S Series Owner's Manual

Getting Started

Attaching the Battery Pack

1. Place the battery pack onto the back
of the radio. It will only  t in one way.
2. Snap the battery release clip until it clicks.
Be sure the battery pack f its tightly against
the radio body.
Avoid exposing the Lithium Ion battery, attached or
unattached to the radio, in direct sunshine, heated cars, or
in areas with temperatures below –20°C (–4°F) or above
+60°C (+140°F).
Exposing the chemicals contained within the battery pack to
temperatures above +60 °C (+140°F) may cause the battery
to rupture, fail or reduce performance.
CAUTION
In case of exposure to cell contents, wash the affected area
thoroughly, and seek medical attention.
Additional battery cautions should be applied as described
on p.2.
To Attach the Belt Clip:
Slide the belt clip into the catch until it snaps into place.
To Remove the Belt Clip:
Pinch and hold the belt clip latch and then slide the belt clip up
and out of the catch.
UNIDEN UH835S/UH850/UH850S
8
Handheld UHF-CB Transceiver