Page 1
UH810S, -2, -2TP UH820S, -2, -2TP Handheld UHF-CB Transceiver For more exciting new products please visit our website: Australia: www.uniden.com.au...
Page 2
The citizen band radio service is licensed in Australia by ACMA Radio-communications (Citizen Band Radio Stations) Class Licence and in New Zealand by MED General User Licence for Citizen Band Radio and NOTE operation is subject to conditions contained in those licenses. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
LCD Display Key Lock System USB Charge port Master Scan Priority Watch UP and DOWN Keys Battery Indicator High Power 10 MENU [MEM] Key Scanning 11 LED 12 PTT KEY Busy Channel 13 SMART KEY Lockout UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Input Voltage (Cigarette Lead Charger): +12VDC to NOTE +24VDC. If Charge LED didn’t light up, please confirm the above temperature. Attaching the Antenna Attach the antenna to the radio. Be sure the antenna is firmly seated. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Slide the belt clip into the catch until it snaps into place. To Remove the Belt Clip: Pinch and hold the belt clip latch and then slide the belt clip up and out of the catch. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
• Do not transmit when the radio is charging; in the drop-in charger or when connected to the DC adaptor! • You can monitor incoming calls while the radio is in the drop-in charger. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Battery Life: More than; 21 hours (UH820S) or 15 hours (UH810S) This is based on the following Duty Cycle: Transmit (Low Power) 5% Receive Stand-by LED Status What it Indicates Green Start Up/Power on Green Flash Monitor mode Green Receiving Signal Transmitting signal UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Accessory Jack Cover Make sure the Accessory Jack Cover is rmly pushed in to maintain submersible rating. Connecting the Earpiece MIC or SPKR/MIC. Release the Accessory Jack Cover to plug in the Earpiece MIC or SPKR/MIC. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Press [MENU/MEM] 2 times. Sq and the current squelch level will ash on the display. 2. Use to change the squelch level from Auto/1 to 5. 3. Press & hold [MENU/MEM] to save and exit. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
45° angle away from your head. Speak in a clear, normal conversational voice. 4. When you have finished speaking, release [PTT] and listen for a response then TX disappears on the LCD. LED lights green while receiving a signal. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
CH41-CH48 when duplex is selected. 3. Press & hold [ to save and exit. MENU/MEM] Contact your retailer for a list of repeaters available in your area. NOTE Operation with the aid of a Repeater UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
SCAN Memories; one for Open Scan (OS) mode and the other for Group Scan (GS) mode, to give you flexibility and allow you to use the radio more effectively. Group Scan and Master Scan modes share the same SCAN Memory. NOTE UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Page 16
3. Press & hold [MENU/MEM] to save and exit. The selected scan mode appears on the display. MS (Master Scan) Press ▲ or ▼ to change the setting OS (Open Scan) Press ▲ or ▼ to change the setting GS (Group Scan) UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
CH09-CH20 are stored into GS Memory and CTCSS01 is set for MASTER SCAN Subcode by default. The GS memory can be changed, UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Page 18
P-: Master Scan uses current CH in GS memory P1: Master Scan uses CH09-20 in GS. P2: Master Scan uses CH21-30, 39, 40 in GS. P3: Master Scan uses CH49-60 in GS. P4: Master Scan uses CH61-70, 79, 80 in GS. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Page 19
Operation 3. Press [MENU/MEM] one more time. 4. Select the desired Subcode (CTCSS DCS) or by pressing ▼ ▲ or . UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
GS and M.SCAN icons. NOTE If SCAN is deactivated while on an active channel, the radio will stay on that active channel. If no channels are active, the radio will reinstate the starting channel. NOTE UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
To select GS scan mode, 1. Press [MENU/MEM] 7 times. 2. Press ▲ or ▼ to change the setting to GS SCAN (Group Scan) 3. Press & hold [MENU/MEM] to save and exit. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
1. Press [MENU/MEM] 6 times. PRI and current channel setting ashes. 2. Press to select the desired channel. 3. Press & hold [MENU/MEM] to save and exit. Recalling the Instant Channel Press [S] when Smart Key is set to Instant Channel function. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
1. Select desired channel. 2. Press [MENU/MEM] 3 times. DCS/CTCSS setting ashes. 3. Press to change the selection. 4. Press & hold [MENU/MEM] to save and exit. Select oF to turn DCS/CTCSS off for the selected channel. NOTE UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
1. Press [MENU/MEM] 10 times. VOX setting flashes. 2. Press to select the desired setting. The 6 VOX levels are from 1 (low sensitivity) to 5 (high sensitivity) and Off. 3. Press & hold [MENU/MEM] to save and exit. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
3. Press & hold [MENU/MEM] to save and exit. Current regulations require calling tones to be restricted to one transmission per minute. If a second transmission is attempted within one minute then an error tone will sound. NOTE UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
This tone can be switched on or off. 1. Press [MENU/MEM] 14 times. bP setting flashes. 2. Press to change the setting on or off. 3. Press & hold [MENU/MEM] to save and exit. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
Choose from 4 different receive audio level settings to provide a natural Voice Enhancer for super clarity and performance. Press [S], when in Smart key EQL mode, to change the setting between; Off(Normal) /L1(Bass) /L2(Midrange) /L3(High) UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
The above situations are not a fault of the radio but a symptom of mixed wideband and narrowband radios in current use. It is expected that as older wideband radios are phased out this issue will be eliminated. UNIDEN UH810S/UH820S Handheld UHF-CB Transceiver...
IMPORTANT: Satisfactory evidence of the original purchase is required for warranty service. Please refer to our Uniden website for any details or warranty durations offered in addition to those contained below. Warrantor: The warrantor is Uniden Australia Pty Limited ABN 58 001 865 498 (“Uniden”).
Page 34
Product, together with satisfactory evidence of your original purchase (such as a legible copy of the sales docket) to Uniden at the address shown below. You should contact Uniden regarding any compensation that may be payable for your expenses incurred in making a warranty claim.