Supermicro SuperServer SYS-211TP-HPTR User Manual page 72

LAN Port Enable/Disable
JPTG1 allows you to enable/disable the onboard LAN ports. The default setting is pins 1-2
to enable the connection. Refer to the table below for jumper settings.
LAN Port AUX Power Enable/Disable
JPAUX1 allows you to enable/disable the LAN port AUX power to enable/disable onboard
LAN ports when the system is in power off status. The default setting is to short pins 2-3 to
disable onboard LAN ports when the system is in power off status. Refer to the table below
for jumper settings.
ME Recovery
JPME2 is used for ME Firmware Recovery mode, which will limit system resource for essential
function use only without putting restrictions on power use. In the single operation mode,
online upgrade will be available via Recovery mode. Refer to the table below for pin definitions.
LAN Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
LAN Port AUX Power Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
ME Recovery
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 ME Recovery
72
Chapter 4: Motherboard Connections